Note on the use of inflatable tents

The inflatable tent belongs to a kind of tent which adopts the principle of structural mechanics to design the frame. The gas pressure is used to expand the airbag to form a column with certain rigidity, and the skeleton of the tent is supported by the organic combination. With the strength of the skeleton material used, the load-bearing size of the tent can be set, and the performance of the polymer coating is used to determine the service life of the frame and the rigidity of the frame, and the rationality of the air chamber setting is Determine the support limit of this framework. Mainly used for moisture, water, wind, dust, sun protection, disaster relief, short-term training in the field, short-term field operations.


The main function
Anti-moisture, anti-mosquito insulation, anti-infrared, flame retardant, ecc. The tent, however, is designed in the shape of a pillar and adopts an internationally popular form. The product has the characteristics of high stability, strong shearing and splitting wind, and no rain.
Assembly knowledge
First select a flat place on the ground, then open the package, spread the inflatable tent on the ground, start to inflate with a high-pressure air pump, stand one person at each corner, pull the rope to prevent the focus from standing upright until it is supported. Finally, the ground anchor was hit and the wind rope was tightened.
common problem


Q: What should I do if the inflatable tent is leaking?
A: If you find any air leaks, you can wipe the air column first and then apply the surface with soapy water to check for leaks. If the leak point is a small hole, you can use a small piece of circular repair cloth (there is a standard for any size of the inflatable tent), then brush the glue, after the glue is dry (important, must wait for the special glue to dry After that, it is attached to the leaking point and the bonding is strict. If the leak is the opening of the air column heat sealing joint, it can be processed in the following steps:
1. Clean the bonding surface first.
2. the inflatable tent will be given a bottle of glue, inflatable tent gas column special glue, brush it on the pre-adhesive surface, must be evenly painted, the thickness is appropriate, after brushing the picture two times, you can glue.
3. the shape of the adhesive interface must be designed to be circular or elliptical, try to avoid square and sharp angle interface shape, the overlap width should not be less than 30mm.
4. After the glue has evaporated, the bonding can be carried out. The patch must be flat, without wrinkles, rolled and smoothed, and the hair source is supplied with a hair dryer to facilitate bonding. After bonding for 6 hours, it can be inflated.

If you want to know more about inflatbale tent ,inflatable camping tent, ecc., you can contact us.

 

INQUISTA ORA